Starter

		Home \| HOW TO GET INVOLVED?? \| PROJECT out line \| CRANK SHAFT \| Design Sequence \| Crankshaft bearings and bearing support \| Conecting rod - pistons \| piston and sleeve rings \| Sleeves \| Wet liners \| Block \| Heads \| Sleeve drive mechanism \| Powers take off (drive end) \| Powers take off (non drive end) \| Oil pumps and system \| Water pump and system \| Alternator \| Starter \| Fuel system \| Motor monitoring \| Exhaust / inlet - manifolds \| Turbo charger \| Mounting \| Propeller and governor \| Design specifications and tolerances \| PEREFERD SUPPLIERS \| The competition \| project # 1 links \| DOWN LOADS \| CONTACT
Caroilne Diesel Engine

Starter

Enter subhead content here

Starting sequence

Starter will spin starter ring gear.

This is connected to the mounting shaft sitting on two bearings or bushes.

On this shaft there is a combination sprag-clutch and bearing.

The sprag-cultch will engage the pulley that has a belt that is connected to the crankshaft.

When the engine starts and the starter motor is stopped, the clutch disengages and the pulley on the shaft free-wheals.

http://www.gmnbt.com/insertelements_technology.htm

this is a site for sprag cluches.